Blow moulded universal caravan and RV water tank which can be configured in many ways to provide a single low cost solution to your water or grey water storage requirements.Blow moulded from food contact approved high molecular weight high density polyethylene. This makes the tank a super tough performer.The tank is moulded with two integral 40mm (1.5” BSP) threaded female closures that can accept a wide variety of standard fixtures and fittings.Using these standard fittings the tank can be networked together to provide many water storage options for your vehicle.
When installation configuration has been chosen, drill a 3-4mm hole in the top of each tank to allow for air venting.Note: Use Teflon sealant tape on fittings and ensure fittings are not cross threaded. Tanks should be fully supported with no load on fittings. Tank may swell when full.